Stay warm this winter
and save MONEY!
No-Cost Winter Energy-Savings Ideas
Set thermostat to 68-degrees or lower
Open blinds and drapes to let the sun warm your home
Ensure Weather-stripping around doors and windows are tight
Ditch the space heater! Using a space heater along with central heating will cost you more. Space Heaters consume a lot of energy and can add $30 or more to your monthly electric bill.
Change the direction of your ceiling fan's paddles. They should circulate air upward.
View Usage Calculator
Year-round energy tips
Set the water heater's thermostat to low
Wash clothes in cold water
Turn off lights and ceiling fans when not in use
Turn off computers and other electronic items when not in use
Use energy-efficient light bulbs like LED’s, which suck less power while putting out the same amount of light and last much longer.
Clean the coils under the refrigerator and increase its lifetime.
Shut off the heat, air, and power to the rooms you are not using.
View Usage Calculator
OTHER WAYS TO SAVE MONEY ON YOUR ELECTRIC BILL
Install a programmable thermostat
Change filters on your air conditioner/heater monthly
Have your A/C and furnace serviced by a professional once a year
Replace incandescent light bulbs with CFLs.
Seal around pipes where they penetrate walls and floors
Improve attic insulation to at least R-38
Use motion detectors or timers to cut down on outdoor lighting times
Improve/replace weather stripping around doors and windows
Consider adding solar screens or window tinting
Replace old appliances with Energy Star-rated appliances!
A/C more than 10 years old? Consider replacing it with an Energy Star-rated unit with a SEER rating of 14 or higher.
Consider replacing single pane windows with low-E Energy Star-rated windows.
Frequently Asked Questions - Click to Open
Is it better to set my thermostat to a high temperature (85-90⚬ F) while at work all day and cool the house when I get home to a comfortable temperature (78-80⚬ F), or to keep the thermostat just a degree or two higher during the day so that the cooling unit doesn’t have to work as hard to cool the house?
You’ll save money anytime you can increase the temperature on your thermostat and cause the unit not to run. The old myth that says you will spend more energy bringing the temperature back down than you would have spent just leaving the thermostat alone is just that, a myth.
What is the recommended thermostat setting during the day?
The Department of Energy (DOE) recommends that you set the thermostat no lower than 78⚬ F when you are home and need cooling. Set your thermostat at as high a temperature as comfortably possible. The smaller the difference between the indoor and outdoor temperatures, the lower your overall cooling bill will be since the unit will not need to run as frequently. Avoid setting your thermostat at a colder setting than normal when you turn on your air conditioner. It will not cool your home any faster and could result in higher electric bills. Assuming that your air conditioner is properly sized and operates on a 20-degree differential (the difference between the temperature inside and outside the home), an AC system would be operating continually if the thermostat was set at 78⚬ F when the outside temperature is at 98⚬ F or more. During summer months in Arizona, we often experience multiple days with temperatures at 100⚬ F or higher. If you’re not at home during the day, set your thermostat higher to stay within the 20-degree differential. Consider a programmable thermostat so that you control how often and when the air conditioner operates.
I never change the thermostat setting. I use the same appliances and equipment every day but my electric bill is outrageous. How is that possible?
The more frequently your AC cycles on and off, the more energy you use. The goal is to keep the thermostat set at a temperature that is comfortable for you, but high enough that the system doesn’t cycle on and off too frequently. If the temperatures outside continue to increase, but you are not also increasing your thermostat, and the temperature differential between the outside and inside temperatures become larger, the AC unit will cycle on more frequently and result in higher energy usage and larger electric bills. Also note that if you have a second refrigerator or freezer that is in unconditioned air (porch, garage, etc.), those units will also work harder to maintain the internal temperature while the outside temperatures continue to rise, resulting in more consumption and higher energy costs. While you might not do anything different from day-to-day or week-to-week, the outside temperatures do play a big part in your energy consumption.
I have never changed the filters on my AC but I’ve been told that I should do this regularly. Every time I check them, they look brand new, just like the day I bought them. Is that okay?
Never having to change your filters is unusual, especially with Arizona’s fine dust. If you’re using very inexpensive filters, they may be too loose to catch any fine dust. This allows the dust to accumulate on the unit’s evaporator coil, which could cause problems later. You might consider the 1-inch pleated filter. A more expensive filter might be too restrictive and could cause problems for your AC unit.
Why do the AC filters have to be changed?
Extreme heat conditions result in an AC unit that runs more frequently in an attempt to bring down the interior temperatures of your home. The air filters inside the unit filter more dust and debris, clogging more quickly than normal. The fan on the exterior unit accumulates debris faster as it constantly revolves. The DOE recommends that you replace the inside filter at least once a month.
How is humidity a factor?
Air conditioners perform two basic functions: heat removal and moisture removal. Even in Arizona, we have a monsoon season with higher-than-normal humidity levels. The lower the humidity, the more comfortable you will feel at a given temperature. As warm indoor air is drawn up through the filter, it passes over a very cold coil whereby the heat and moisture are removed. If you’ve ever noticed a PVC pipe running off your roof that drips water, that is the moisture removed from your home. When the humidity is high, it makes sense that the AC system is working harder to keep your home cool. If you have an older, inefficient or wrong-sized system, it may not handle the job and you may end up feeling warmer than it actually is because the air is holding extra moisture that isn’t properly removed. If your AC system is working longer and harder, this can add wear to the unit and can result in higher utility bills.
I have two AC units, one upstairs and one downstairs. How do we set them up for comfort and energy savings? Should they be set at different temperatures?
Because heat rises and extra heat gain exists on the second floor, the upper level will likely require more cooling than the lower level. To maintain a constant temperature in your home, set each thermostat at the same temperature. However, if you want to reduce energy costs, you can maintain a comfortable temperature on the floor you are occupying. If you’re not using the upstairs, set the second-floor thermostat a couple of degrees higher. Reverse the process at night when you’re upstairs.
How can I manage my usage?
Sign up for SmartHub. This application provides convenient account access to Usage Explorer, giving you a detailed look at your past and current usage, all in one place. You can view your usage and weather trends by month, or if available, by day. Along with daily consumption, you can see the high, low and average temperatures with an option to view the daily cost. Many TRICO members are utilizing this tool in an effort to reduce their power bills.